After a subproject has been filed off, this property is displayed automatically on the first tab in the properties table at the respective objects with cross-references (for example interruption points, PLC connection points, coils, etc.). In a subproject the cross-references to the counterpieces located in the original project are stored in the Cross-reference (external) property. In the case of such a "sub-subproject" the subproject number (for example 002) is separated by a further underline and attached with supplementary zeroes (for example EPLAN-DEMO_). This means that you have to define new defined working sections in order to divide a subproject further. In a subproject the defined working sections have been reset to the original state. To do so you have to specify defined working sections for the subproject as well and activate a defined working section. The division of a subproject into further subprojects is possible. Previous changes can cause unexpected results and errors. You can subsequently file off the subprojects again. Therefore do not change the properties, settings and master data of the original project again until after all the subprojects have been stored. After subprojects have been created, these data and settings may not be changed either in the original project or in the subproject.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |